Hey guys, I’ve just completed my first prints. The top surfaces and sides came out really good, but the undersides came out a little rough. Especially where supports were, what’s the accepted standards for cleaning these areas up? Sandpaper, files, dremel?
What settings should I be looking at to make my next prints even better in these areas?
My setup: Qidi xplus3 Sunlu PLA + 2.0 (using its default filament profile in orca) @ 230/60 300blkfde’s orca/machine settings. 12 walls, 80% infill. Layer height: .2 Support distances: .19
I appreciate the feedback!
I’ve had good luck with an orbital sander, but it’s going to be a bitch what ever post processing you’re going to do
Yea I’m still not sure. I gotta clean some of it up as it still has little bits of supports stuck in places. This pic was after just popping all the supports off.