Sorry guys. I’m new here and fairly new to 2A printing. Just got my centauri carbon set up. .6 hotend, running fiber on pa6-cf. I have it running directly from my dryer into the machine via ptfe tube. I know I want to use 100% infill, but I’m not sure about the rest of my settings. Can someone direct me to a rundown of the settings I want to use?
Going to start with a couple fmda Glock frames and some Hoffman lowers.
I’ve been printing for several years now. Started with an ender 3 v1 and have upgraded as money allowed. I’ve even done a couple 2A prints (fgc that didn’t turn out and a harlot). Printer is as dialed in as I can make it. I was mostly looking for recommended speeds, wall settings, etc.
Sounds like you should be just fine moving up to a better printer and material! This is a good starting point for setting with PA6-CF. https://guncadindex.com/detail/300blkFDE-Filled-Nylon-Settings:c